Water Raters are a handy addition to your home.

They are a convenient way to keep your water cool when it’s cold outside, and when it is hot.

Here’s how to use one.

1.

Clean the Water Source A water radiator is an appliance designed to heat water.

It consists of a copper pipe and a metal tube.

You’ll want to remove all the screws and bolts, then replace the copper pipe with a stainless steel one.

To do this, just remove the bottom of the pipe and put it back in place.

Remove the heat exchanger and place it on the other end of the tube.

Next, you’ll need to remove the copper tube from the bottom, which is where the water flows.

Place a towel under the copper and carefully remove it.

Next comes the water pipe, which you’ll have to unscrew and replace.

Now you’re done!

Here’s the best part: you can keep the water cooler while you clean your water pipes.

2.

Drain the Water From the Water Rator Source This is an easy way to make sure that the water stays cool while you’re cleaning your pipes.

Just unscrew the bottom piece of the copper tubing, and you’ll be able to see where the drain valve goes.

Place the pipe back on the pipe, and repeat the process to remove any remaining copper tubing.

The drain valve will come out, and there you have it: a water radiator.

3.

Clean Up the Water from the Water Tank Source This time, you’re going to clean the water tank from the inside out.

Remove all the excess plastic, metal, and metal parts.

Next is the water pump.

Remove that cap, and then replace it with a rubber one.

The hose and fittings will now be clean, and the water will drain right out.

4.

Reinstall the Water Pump Source This one’s a bit trickier.

The pump is a single tube, so there’s only one part to do.

Remove a few screws and push the pump on the water valve.

The tube will come loose, and just follow the instructions below.

5.

Disconnect the Water Supply From the Pump Source Now, we need to disconnect the water supply from the pump.

There’s a hole in the water line that goes to the water radiator, so take the water out of the pump and remove it from the water lines.

Then, plug the hose back in.

Then put the pump back in the system.

You should be done!